Remote Control Operation - Friedrich Chill CCF05B10B Installation And Operation Manual

J.2 Remote Control Operation
1. Power: Turn the air conditioner on and off. This button will clear the TIMER setting.
2. MODE: Press the button to select the mode of operation, AUTO, COOL, DRY, FAN ONLY, HEAT.
Note: The HEAT mode is only for some heating models. If you do not need it, press the MODE button for
more than 5 seconds to delete the HEAT function, and the COOL mode will be selected automatically. Press
the MODE again for more than 5 seconds to add the HEAT function, and the HEAT mode will be selected
automatically.
3. + And - : Use these buttons to increase or decrease the setting Temperature or Timer. Setting
temperature range: 61 ~88°F.
Note: After setting temperature with remote using the + and - buttons, both the remote display
and the unit display will automatically turn off after a short time. This does not affect the unit
operation.
4. TURBO: When the remote is ON, press the button to activate the TURBO function, under
AUTO/COOL/FAN ONLY mode. Press again to cancel the TURBO function, and the fan speed will
change to pre-setting before.
Note: °F and °C change: After inserting the batteries, in the off state within 3 minutes, press
the TURBO button for more than 5 seconds to switch the Fahrenheit (°F) or Celsius (°C) degree
display.
5. DISPLAY: When the unit is ON, press the button, to switch off/on all lights or LED display. And
this function will be canceled when changing mode.
6. TIMER: Use the button to set the TIMER, or cancel the TIMER.
TIMER OFF: When the unit is ON, the timed OFF is programmed by pressing TIMER button, the
remote will display 6 hours pre-setting at first.
Set the rest time by pressing the button or until the needed rest time display, then press TIMER
button again to confirm.
TIMER ON: When the unit is OFF, the timed ON is programmed by pressing TIMER button, the
remote will display 6 hours pre-setting at first. Set the rest time by pressing the button or until
the needed rest time display, then press TIMER button again to confirm. Later, the remote screen
will keep display [TIMER] icon.
Note: When TIMER ON, it cannot select Sleep mode, but can pre-set Mode, temperature, fan
speed, ECO.
7. SLEEP: Press the SLEEP button, all of the display lights will turn off after a while, but the
Sleep light is always on. In SLEEP mode, the air conditioner will automatically adjust the tem-
perature and fan speed to make the room more comfortable during the night. The set tempera-
ture will automatically raise every 30-60 minutes and at most change six times until the set
temperature is 81 or 82°F. This function can be selected when COOL or HEAT mode.
8. FAN SPEED: Press the FAN SPEED button to choose the fan speed options. You can choose Hi,
Med, Lo or Auto speed in COOL or HEAT mode and choose Hi, Med, Lo in FAN mode. When DRY
mode, it is only Low fan speed.
9. MONEY SAVER: When the unit is in COOL mode, press the button to MONEY SAVER function.
In MONEY SAVER mode, the unit will turn off once the room is cooled to the user set tempera-
ture. The unit will turn back on when the room temperature rises above the user set tempera-
ture. Before the compressor starts, the fan motor will run for 20 sec., then it will stop for 10
min., and will repeat to provide a much more comfortable feeling and save energy.
Battery size: AAA
Note: Do not mix old and new batteries or different types of AAA batteries.
J. STARTUP AND OPERATION
1
3
9
8
7
2
3
4
5
6
19