Craftsman 320.28160 Product Manual page 16

ATTACHING THE FENCE TO
THE TABLE (Fig. 6)
_, WARNING: Always
unplug the router before at-
taching or removing the fence.
The fence has been shipped
completely assembled.
1. Place the fence assembly
on the table with the four
wing nuts facing toward you.
2.
3.
Align the two holes on the
bottom of fence assembly
with the two channels on
the router table.
Secure the fence to the
table with two clamping
knobs (5), two plain washers
(11), and two short, round-
head, square-neck bolts (6).
TO ATTACH THE MITER
GAUGE (Fig. 7)
The miter gauge has been
shipped completely assembled.
Attach the miter gauge to the
table by placing the miter-gauge
bar in the slot on the table.
MOUNTING THE TABLE TO
AWORK SURFACE (See Fig. 8)
1. Place the router table, up-
right, on a sturdy surface,
e.g., work stand, work-
bench, or counter top.
2.
While holding the router
table in place, mark on the
work surface the location
of the two mounting holes
(11/32-in dia.) in each of
the legs.
3. Remove the router table.
Fig. 6
Fig. 7
Fig. 8
®
28160 Manual_Revised_07-0228 Page 16