Storage; After Each Use; Winter Storage - Craftsman 580.752420 Operator's Manual

7.0 gross horsepower 3000 psi 2.3 gpm pressure washer
Table of Contents

Advertisement

Available languages

Available languages

AFTER EACH USE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump
parts and "freeze" pump action. Follow these
procedures after every use:
1.
Flush detergent siphoning tube by placing the filter
into a pail of clean water while running pressure
washer in low pressure mode. Flush for one to two
minutes.
2.
Shut off engine, turn off water supply, point gun in
a safe direction and squeeze trigger to relieve
trapped pressure, engage
trigger
lock on spray gun
and let engine cool.
WARNING
Keep
high pressure
hose connected
to pump
and spray
gun while
system
is pressurized.
ALWAYS
point
gun in safe direction
and squeeze
spray
gun trigger,
to release
high pressure,
every time
you stop
engine.
Engage
trigger
lock when not in use.
3.
Disconnect hose from spray gun and high
pressure outlet on pump. Drain water from hose,
gun, and nozzle extension. Use a rag to wipe off
the hose.
4.
Empty pump of all pumped liquids by pulling recoil
handle about 6 times. This should remove most
liquid in pump.
5.
Coil high pressure hose and properly hang it on
hook provided on accessory tray.
,
7.
Store unit in a clean, dry area.
If storing for more than 30 days see "Long Term
Storage" on next page.
WARNING
WHEN
STORING
FUEL
OR EQUIPMENT
WITH
FUEL
IN
TANK
Store away from furnaces,
stoves,
water
heaters,
clothes
dryers
or other appliances
that have pilot light or other
ignition
source
because
they can ignite fuel vapors.
WINTER
STORAGE
CAUTION
• Failure
to do so will permanently
damage
your pump
and render
your
unit inoperable.
• Freeze
damage
is not covered
under warranty.
To protect the unit from freezing temperatures:
1.
Follow steps 1-5 in the previous section "After
Each Use".
2.
Use pump saver, available at Sears retail item
71-74403, to treat pump. This minimizes freeze
damage and lubricates pistons and seals.
3.
If pump saver is not available, connect a 3-foot
section of garden hose to water inlet adapter. Pour
RV-antifreeze
(antifreeze without alcohol) into
hose. Pull recoil handle twice. Disconnect 3-foot
hose.
4.
Store unit in a clean, dry area.
21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents