NAILING
OPERATION
Refer to Figures 2 & 3, pages 4 and 6.
WARNING:
Do not operate tool with-
out fasteners or damage to tool may
result. Never pointthe tool at yourself or
others.
•
Positionand place the fastener
where it must be applied.
•
Slide the nailer on to the fastener so
that the magnets in the guide bush-
ing (Key No. 18) contact the fastener
head.
•
Hold body firmly with palm on the
palm rest and fingers on the finger
rest. If necessary, use other hand on
the handle.
•
Gently push nailer against fastener
head to activate.The nailer will auto-
matically stop when the nail is driven
completely.
Palm Rest
Finger Rest
OPERATING
PRESSURE
•
Use only enough air pressure to per-
form the operation. Air pressure in
excess of that which is required will
make the operation inefficientand
may cause premature wear or dam-
age to the tool.
•
Determine minimum air pressure
required by driving some test fasten-
ers intothe workpiece.Set air pres-
sure so that test fasteners are driven
down flush with the work surface.
Fasteners driven too deep may dam-
age workpiece.
_uide
Handle
l
J
Flgure 2 - Nailing Operation
4