SPECIFICATIONS
Nail length ...........
2_5" (5d-40d)
Nail head size (dia.)........
V,to ,3/=,,
Nail size (dia.) ............
%, to 3/_,,
Operating pressure ......
60-100 PSI
Air inlet .................
V," N.RT.
Length.......................
8"
Height ...................... 51/2 , '
Width ......................
33/, "
Weight..................
1.50 Ibs.
AIR SUPPLY LINE
Refer to Figure 1.
•
The air tool operates on compressed
air at pressures from 60 to 100 PSI.
•
Never exceed maximum pressure.
Minimum air requirements for tool:
Average working SCFM 2.6 at 90 PSI.
WARNING:
Keep hands and body
away from discharge area of tool when
connecting air supply.Always discon-
nect tool from air supply when servicing
or adjusting tool and when tool is not in
use.
•
Air operatedtools require clean, dry,
compressedairto ensuretop perfor-
mance, lowmaintenance and long life.
•
Dirt and abrasive materials present
in all air lines will damage tool
O-rings, valves and cylinders.
•
Moisture will reduce tool perfor-
mance and life if not removed from
compressed air.
•
A filter-regulatorsystem is required
and should be located as close to
tool as possible (see Figure 1). A
distance of less than 15 feet is re(:-
ommended.
•
Keep air filter clean. A dirty filter will
reduce the air pressure to the tool
causing a reductionin power and
efficiency.
•
The air supply system must be able
to provide air pressure of 60 to 100
pounds per square inch at tool.
•
All hoses and pipes in the air supply
system must be clean and free of
moisture and foreign particles.
•
Do not mount swivel connector in air
supply line.
• The air pressura shouldbe properly
regulated.
•
Different workpieco materials and
fastener lengths will require different
operating pressure.
•
Be sure all connections in air supply
system are sealed to prevent air loss.
Never connect a female quick*dis-
connect couplingto the tool side of
air line connection.A male, free-flow
coupling shouldbe connected to the
tool side of air line connection.
WARNING:
The female couplingpro-
vides a seal preventing loss of com-
pressed air from compressortank when
disconnected from male coupling. If
connected to tool side of air supply,the
female couplingcould seal a com-
pressed air charge in the tool which
coulddischarge if the trigger is
actuated.
2 Foot HoseWhip
Male Quick-Disconnect
Filter- Regulator
Female
Quick-Disconnect
Figure 1 - Air Supply Line
3