Table of Contents
Advertisement
Installation
7
Site Preparation
1
Position the unit on a flat, level surface
capable of supporting the entire weight of the
unit. Remember the unit will be significantly
heavier once it is fully loaded.
2 This unit requires a grounded and polarized
115 VAC, 60Hz, t5A circuit (normal
household current).
3 Avoid connecting the unit to a Ground
Fault Interruptor (GFI). GFIs are prone to
nuisance tripping which will cause the unit to
shut down. GFIs are generally not used on
circuits which power equipment that must run
unattended for long periods of time.
4 The unit must be installed according to your
local codes and ordinances.
WARNSNG
ELECTROCUTION
HAZARD!
Electrical
Grounding
Required. This appliance
is equipped with a three prong (grounding)
polarized plug for your protection against
possible shock hazards.
, NEVER remove the round grounding
prong
from the plug.
o NEVER use a two-prong
grounding adapter.
NEVER use an extension
cord to connect
power to the unit.
Where a two-prong
wall receptacle
is
encountered
or a longer power cord is
required,
contact a qualified
electrician
to
have it replaced in accordance with applicable
electrical
codes.
6
7
Wipe out inside of unit with a damp cloth.
Be sure to install the Anti-Tip bracket, Follow
the instructions provided with the Anti-Tip
bracket kit.
The Anti-Tip Kit must be installed on this unit
before it is used. Double stacking units may
cause serious personal
injury.
5
Position the unit to allow free air flow through
the front grille.
Advertisement
Table of Contents
