Electrolux E24WC75HPS - Icon - Professional Series 48 Bottle Wine Cooler Service Data Sheet

PERFORMANCE DATA NO LOAD & NO DOOR OPENINGS
AT MID-POINT CONTROL SETTING
type a with run/start
65°f (18°c) ambient
capacitor
Operating Time N/A
Wine Cooler Temperature 45º F to 65º F
30 to 45 psig
Low Side Pressure (cut-in)
208 to 310 kPa
-2 to 4 psig
Low Side Pressure (cut-out)
-14 to 28 kPa
High Side Pressure 90 to 120 psig
(last 1/3 cycle) 621 to 827 kPa
Wattage (last 1/3 cycle) 85 to 125
Amps (running) .75 to 1.2
Base Voltage 115 vac (127 vac max)
cONdeNser faN mOtOr
Watts rpm
3.1 1100 CW Opposite Shaft
WiNe cOOLer evapOratOr faN mOtOr
1.7 each 9000
impOrtaNt safety NOte
The information provided herein is designed to assist qualified
repair personnel only. Untrained persons should not attempt
to make repairs due to the possibility of electrical shock.
Disconnect power cord before servicing this appliance.
impOrtaNt
If any green grounding wires are removed during servicing,
they must be returned to their original position and properly
secured.
impOrtaNt: pLease returN this sheet tO
it's OriGiNaL LOcatiON.
service data sheet
90°f (32°c) ambient
cautiON
14 to 37%
all electrical parts and wiring must be shielded from torch
45º F to 65º F
flame. dO NOt allow torch to touch insulation; it will char
30 to 45 psig
208 to 310 kPa
at 200°f and flash ignite (burn) at 500°f. excessive heat will
-2 to 4 psig
distort the plastic liner.
-14 to 28 kPa
130 to 175 psig
896 to 1207 kPa
85 to 125
unit dimensions - icON desiGNer
.75 to 1.2
amps
0.03 Running
.02 each
241957100
WiNe cOOLer - r134a
NOte
Your Electrolux wine cooler has been designed for either free-
standing or built-in installation. When built-in, your wine cooler
does not require additional air space for top, sides or rear. In
either case, the front grille must NOt be obstructed.
To ease unit installation and removal, it is recommended that
the cabinet rough opening dimensions be increased by at
least ¼ inch over the dimensions given for your unit.
All units require zero clearance when installed flush with a
cabinet or wall. Electrolux stainless steel models require a
2-11/16" (PRO) or 2-1/16" (DESIGNER)
minimum
clearance when installed against a wall or cabinet that extends
beyond the front edge of the unit.
unit dimensions - icON prO
handle