Table of Contents
Advertisement
ADJUSTING THEOR
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
Your door is aligned
at the factory before shipment.
OccasionaU re=adjustment
may
be necessary,
especially
if an overlay paneU is installed.
The following
procedure
will correct for up to 1/4" alignment.
The door shouUd never be flush with the top of the cabinet.
Even when ReveU, t he top
edge of the door will be 1/8" below the top of the cabinet
(see Figure
14).
,_1/8"
t
Figure 14
To adjust :
1
Compare
the top edge of the door (opposite
the
hinges) to the top edge of the cabinet
and note the
type (up or down) of adjustment
needed.
2
Remove
the top hinge pivot pin with a 7/64" hex
wrench
(see Figure
15) and lift door off bottom
hinge pin. Be careful not to lose door closers
(see
Figure
17).
3
With door upside-down,
loosen but do not remove
the two hinge plate screws.
Figure 15
f
Advertisement
Table of Contents
