Table of Contents
Advertisement
Tostainfor a differentwoodcoUor:
2
3
4
5
6
Removefive rackswith woodtrim from unit,see Rack RemovaV
lnstallatiorL
Remove
screws
securing
wood trim to racks.
AppUy Minwax
Water-Based
Wood Stain® to wood with a synthetic
foam
brush. Stain must penetrate
approximateUy
3 minutes. After this period, while
stain is still wet, take a stain dampened
rag and remove
aUlexcess stain.
Wipe in the direction
of the grain with medium pressure
to achieve the
desired
stain coUor.
After 2 hours, repeat step three. This will even out the coUor of the wood.
AHow stain to dry for a minimum
of 3 hours before finishing.
tf desired
sand the wood with very fine sandpaper
to smooth the surface
from
the staining
process.
Remove
aUU dust from the wood. Apply one coat of Minwax
Ultra Fast-Drying
Polycrylic
Protective
Finish® with a synthetic
foam brush to the wood. This
finish should be applied
in a thin coat following
the direction
of the grain. First
apply the finish to the back and sides of the wood. Allow this to dry for two
hours. Next apply the finish to the front side of the wood and allow to dry for
two hours. Sand with very fine sandpaper
(220 grit). Reapply
in the same
manner
3 times total. After the third coat do not sand the surface.
Allow the final coat to dry for 24 hours before installing
the wood to the wine
cooler
racks.
Advertisement
Table of Contents
