Door Reversal; Reversing The Door - Electrolux Wine Cooler / Beverage Center Use & Care Manual

8

Door Reversal

Reversing the Door

To reverse the door:
1 Disconnect power to the wine cooler /
beverage center.
2 Remove toe grille by removing two (2) Philips
screws. Remove plastic cap, reverse it and
place it in the other side of the toe grille.
3 Disconnect door harness from connector
bracket behind lower front panel. Pull
harness from behind lower front panel so it is
hanging below the door.
4 Remove upper right-hand (RH) hinge bracket
by loosening four (4) Torx screws. Be careful
to support the door while loosening and
removing the upper hinge bracket.
5 Lift the door off of the lower RH hinge
bracket. Turn the door upside down and
place on a soft, non-abrasive surface.