This model comes equipped with a right-hand (RH)
swing door. To convert the unit to a left-hand (LH)
swing door (as shown in the Use & Care Guide),
certain components must be obtained before
beginning the conversion. These components
are available from your local dealer or by calling
Order Part Number:
(Models EI24 WC65GS & EI24BC65GS)
To reverse the door:
Disconnect power to the wine cooler /
Remove toe grille
Remove upper RH hinge bracket by
loosening four (4) screws. Be careful to
support the door while loosening and
removing the upper hinge bracket.
Lift the door off of the lower RH hinge
bracket. Turn the door upside down and
place on a soft, non-abrasive surface.
Disconnect door harness from connector
bracket behind lower front panel. Pull
harness from behind lower front panel so it is
hanging below the door.