mnterior C leaningoAs Required
1
Disconnect
power to the wine cooUer.
2
Remove
racks if desired, see WINE RACK REMOVAL/INSTALLATION.
3
Wipe down the interior with a soUution of non-abrasive
mild detergent
and
warm water.
4
Rinse with cUear water.
5
Reconnect
power to the unit.
CondenserCleaning- Every3 Months
i
ii'
"_
Figure 25
To remove
and replace
the grille for access to
the condenser
fins foUlow this procedure:
1.
Remove
the controU knob by grasping
the
knob and pulling straight
off (see
Figure
25).
2.
Remove
the screws
at each end of the
grille.
3.
Remove
the grille.
4
Clean the condenser
coil using a brush or vacuum
cUeaner. Do not touch.
5
Position the grille to align the screw hoUes with the cabinet.
6
Insert the grille screws and tighten being careful not to over tighten.
7
Install the control knob by aligning the flat of the control knob with the flat on
the shaft. Push firmly.