Water And Electrical Requirements - EdgeStar SW5L30D Use And Care Manual

Water and Electrical Requirements
Electrical
::OV_ GOl ::(iAmp fuse or circuit breaker
We recommend a d¢_dicalod circuit meant only for the wash¢_ d_yc¢.
The wash dryf' is equipped with a power cord and al_¢'¢'pcn(_ NIHAS201P p[u<_
He_e _se a'_ Extem_sion co,do
An electrical ground is required on this appliance. This unit is equipped with a four prong
grounding plug for use in a properly installed and grounded outlet.
Warning
Improper connection of the equipment grounding conductor can result in a risk of electric shock. Check
with a qualified electrician or servicer if you are in doubt on grounding the appliance. Do not modify the
plug provided with this appliance. Have a qualified electrician install the plug into the wall receptacle if the
plug does not fit the outlet. To prevent risk or fire, electric shock or personal injury all wiring and ground-
ing must be done in accordance with National Electrical Code, local codes and ordinances. The owner of
the appliance is responsible fo povifi_; adequate electrical service for this appliance.
Water
Water pressure of 30 to 120 p.s.i, is required to correctly fill the w_:;h_ d y_r. Pressure of less than 30
p.s.i, may cause a failure in the water valve or extended fill time. The inlet valve system may not shut off
correctly. To avoid the possibility of water damage should a hose leak, always have faucets accessible.
Turn off faucet when waste dye is not in use.
Drain Facility
We recommend the height of the standpipe to be not higher than 2.63ft and not lower than 1.64 ft.
Make sure the drain facility is capable of accepting the d_in ho_u_ in a secure manner.
Flooring
For best performance the unit must be installed on a solidly constructed floor. Wooden floors need
reinforcement to minimize machine vibration. Carpeting and soft tile surfaces are contributing factors in
vibration and may cause the wash_ dw to move slightly during the spin and dry cycles. Never install
the wash ;_ dye on a raised platform or on any weak structure. Proper flooring is the responsibility
of the owner.
Location
We recommend the w_,sh_, _o/b_, _:,lallf, d in areas where water may freeze or boil.
waste d y_ ma fl_i_ssom amoL_fl ofwab _ i_fl _ _ally al all im_:,s :ompon_:,nlslike
h<- wJve lhe t_un p, and i_ the hose areas :_f ths v,_b:_r _re_:_zes it (:a_ d_n aci;;ebelts, the ptnt b
tse motor_ ]oseso otser :omp(nents f4ake s{re the o-,erating tempealure is not below
60 deg ees I:: Your washer dryer is a ventless system, therefore it can be installed in a closet
or in an alcove.
Warning
Your washer dryer is manufactured for operation on 60Hz AC approved electrical service. This
model is not designed for use on 50 Hz AC electrical service. We do not recommend conversion.
For Technical Assistance or if your washer dryer requires service, replacement parts or
accessories contact Tech_ica_ Services a_d S_ort tol_ _ree at _ 877_447 8772_
Page 8