EdgeStar CW1200 Troubleshooting Manual

Questions?
Use This
PROBLEM
Washer won't fill, rinse
or drum will not turn
Drum does not fill, but
Water is flowing
Washer dryer stops
Washer won't drain
Washer continues to fill
or drain or the cycle
seems stuck
Washer makes noise

Troubleshooting Guide

POSSIBLE CAUSE AND REMEDY
• Is power cord plugged into a proper power receptacle?
• Is Wash Program knob pointing to the correct program number?
• Is water inlet hose kinked?
• Is water pressure at the tap correct? Is the tap ON?
• Is the door closed?
• Is the fuse blown or circuit breaker tripped?
• Are shipping bolts
• Are knobs rotated clock wise?
• Is your Wash Program
• Is your drain hose fixed at the correct height?
• Is the power cord plugged into a proper power receptacle?
• At the start of the cycle
laundry quickly. This creates a perception that water is not flowing.
• This is normal, allow the program and the cycle to continue.
• Is power cord plugged into a
• Are all knobs correctly
• Is water inlet hose blocked or kinked? Is the tap on?
• Is there electrical power at the wall receptacle?
• Call an electrician to check the wall socket.
• Are you using an extension cord? Do not use an extension cord.
• Is the drum overloaded with laundry?
• Is the lint filter clogged? ( Do not open while unit is full of water).
• Is the drain hose clogged? Is the end of drain hose more than
2.63 ft above the floor?.
• Is the lint filter clogged? ( Do not open while unit is full of water).
• See installation instructions for proper installation of drain hose.
• Is the door open?
• Are there excessive suds?
• Is your voltage low? Check your electrical service or call an
electrician. Do not use an extension cord.
• Is the end of the drain hose more than 2.63 ft above the floor?
• Is there a air gap in the drain hose?
• Is the lint filter clogged? ( Do not open while unit is full of water).
• Are all knobs correctly positioned?
• Is the unit plugged into a
• Is voltage low? Check electrical service or call an electrician.
• Are shipping bolts
• Are gears engaging? These are normal
• Coins or safety pins
• Heavy wash loads can produce a thumping sound. This is normal.
• Is the Washer Dryer levelled?
on the floor?
• Adjust leveling legs if necessary.
• Is your flooring correct?
and spacers removed?
knob working correctly?
Water inflow is low and is absorbed by the
proper power receptacle?
rotated?. Do they point to the program?
proper power receptacle?
and spacers removed?
Washer Dryer
or other metals items
Are all four feet resting firmly
noises.
may be in the drum