Carburetor; Throttle Control Cable - Craftsman 536.252570 Owner's Manual

SERVICE AND ADJUSTMENTS
TO REMOVE HOOD (See Figs. 41 and 42)
• Raise hood,,
o Disconnect headlight wire harness connector.,
• Remove screw used to attach hood lanyard to side of
engine, Hold hood securety to prevent hood from falling
® Remove clevis pins and hairpins used to attach hood to
mounting brackets+
• To reinstall, reverse above procedure
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
(See FIG. 43)
The throttle control has been preset at factory and adjustment
should not be necessary, If adjustment is necessary, proceed
as follows:
Q
Q
With engine not running, move throttle control lever to
FAST position or detent postion+
Loosen clamp screw so throttle cable can be moved in
cable clamp+ (Do not remo'_e cable cJamp from controJ
bracket or disconnect remote control cable from control
lever)
Move control lever to FAST position and hold in this posi-
tion.
Tighten clamp screw securety so cabte clamp will hotd
remote control cable in place when remote equipment is
used,,
The engine controls should now be adjusted corretfy,,
TO ADJUST CARBURETOR
The carburetor has been preset at the factory and adjustment
should not be necessary. However if you think your carburetor
needs adjusting, see your nearest SEARS SERVICE
CENTER.
HOOD LANYARD
Fig° 41
HEADUGHT WIRE HARNESS CONNECTOR
HOOD MOUNTING
BRACKET
VIEW FROM RIGHT SiDE OF TRACTOR
HOOD
HAIRPIN
HOOD MOUNTING
BRACKET
VIEW FROM RIGHT SIDE OF TRACTOR
Fig+ 42
CONTROL BRACKET
CONTROL LEVER - IN *'FAST"
POSMON (HOLE IN LEVE
, IN LINE WETH NOTCH IN
THROTTLE
CABLE
CLAMP
SCREW
,
FIG,, 43
33