Fuse; Headlight Bulb; Interlocks And Relays - Craftsman 536.252570 Owner's Manual

SERVICE AND ADJUSTMENTS
L
TO START ENGINE WITH A WEAK
BATTERY (See Fig. 38)
When you charge the battery, do not smoke.
Keep the battery sway from any sparks. The fumes from the battery acid can cause an
explosion°
Ifyour batteryisloo weak to start the engine,itshouldbe
recharged, If "jumper cables" are used for emergency starling
follow this procedure,
IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A t2
VOLT NEGATIVE GROUNDED SYSTEM. OTHER VEHICLE
MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED
SYSTEM. DO NOT LISE YOUR TRACTOR BATTERY TO
START OTHER VEHICLES.
TO ATTACH JUMPER CABLES -
o Push battery boot sway from POSITIVE (+) terminal
@ Connect RED (+) cabFe to POSITIVE (+) terminal en
battery, taking care not to short against chassis.,
o Connect BLACK (-) cable to NEGATIVE (-) terminal on
battery:
TO REMOVE CABLES, REVERSE ORDER -
® BLACK (-) cable from battery,
• RED (+) cable from battery.
TO REPLACE FUSE (See Fig. 39)
• Raise hood.
® Locate fuse herder under dash,
o Remove fuse and rap{ace with a 15 amp automotive-
type plug in fuse (see REPAIR PARTS section for more
information).
TO REPLACE HEADLIGHT BUI.B
(See Fig. 40)
• Raise hood_ NO'rE: Do not remove plastic headlight lens
when replacing headlight bulb
• Turn headlight harness (holding bulb) 1/4 turn counter-
clockwise and remove.
• Puli butb out (do not unscrew). Push in new bulb..
• Replace headlight harness and turn 1/4 turn clockwise to
lock in ptaca.
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly,
stop running, or prevent it from starting
• Checkwiring See eleci.rical wiring diagram in the RERAIR
PARTS section of this manual
NEGATIVE (-)
TERMINAL"
DASH
WIRE HARNE_
FUSE HOLDER
POSITIVE (,)
TERMINAL
RUBBERBOOT
Fig. 38
FUEL TANK
FIG. 39
HOOD
HEADUGHT
LENS
BuLB HEADLIGHT
HARNESS
'3"3
Ftg. 40