Advertisement
Available languages
Available languages
Contents
of Carton
1 - Air Compressor
2-
Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
2 - Rubber Bumpers
2 - Screws, 1/4-20
x .75"
Tools Required
for Assembly
1 - 9/16" socket or open end wrench
1 - 1/2" socket or open end wrench
Unpacking
1.
Remove all packaging
leaving
the air compressor on the pallet.
2.
Remove and discard the (4)
screws holding the air
compressor to the pallet.
It may be
necessary to brace
or support one side of the air
compressor when removing the
pallet because the air compressor
will have a tendency to tip.
3.
Carefully remove the air
compressor from the pallet.
Assemble Wheels
It will be necessary
to brace or support
one side of the air compressor
when installing the wheels because
the compressor will have a
tendency to tip.
1.
Attach wheels with shoulder
bolts and nuts as shown.
[_
_ _
Rubber
Nut
_
whee,Z /
Shoulder
Bolt
2.
Tighten securely. NOTE: The air
compressor
will sit level if the
wheels are properly installed.
I_'_'j_
The wheels and
handle do not
provide adequate clearance,
stability or support for pulling the
unit up and down stairs or steps.
The unit must be lifted, or pushed
up a ramp.
Assemble Rubber Feet
1.
Attach rubber feet with the
screws provided as shown in
previous figure.
2.
Tighten securely.
D27299
10-ENG
Advertisement
