Clamping Workpiece To The Fence; Clamping Workpiece To The Saw Table - Craftsman 315.212240 Operator's Manual

CLAMPINGWORKPIECE TO THE FENCE
• Insert the grooved end of the clamp extension rod
as far as it will go into the front hole of the clamp
support. This will allow the clamp to press the
workpiece against the fence. See Figure 44.
CLAMPSUPPORT
o
v CLAMP
SCREWS EXTENSION ROD
CLAMPWORKPIECE TO THE FENCE
Fig. 46
• Secure the clamp extension rod with a screw.
• Slide the clamp assembly onto the clamp exten-
sion rod and secure with a screw.
Note: The clamp assembly can be slid forward or
backward on the clamp extension rod as needed
by loosening the screw.
• Turn the knob to secure and free the workpiece
against the fence.
• Securely tighten a14 screws on the clamp before
each use.
• Before making a cut, always check the blade and
blade guard clearance over and around the miter
clamp.
WARNING: Make sure the saw blade or blade
guard will not hit the work clamp assembly when
cutting miter and bevel cuts. Failure to heed this
warning could result in serious personal injury.
CLAMPING WORKPIECE TO THE SAW TABLE
• Insert the grooved end of the clamp extension rod
into the back, top hole of the clamp support. This
will allow the clamp to press the workpiece against
the saw table. See Figures 42 and 45.
KNOB
CLAMP
EXTENSION ROD
SCREWS
CLAMPSUPPORT
CLAMPWORKPIECE TOTHE SAW TABLE
Fig. 47
• Align the groove in the clamp extension rod with
the screw hole, and secure the rod with a screw.
• Slide the clamp assembly onto the clamp exten-
sion rod and secure with a screw.
Note: The clamp assembly can be slid forward or
backward on the clamp extension rod as needed
by loosening the screw.
• Turn the knob to secure and free the workpiece
against the saw table.
• Securely tighten all screws on the clamp before
each use.
• Before making a cut, always check the blade and
blade guard clearance over and around the miter
clamp.
,_ WARNING: sure saw blade or blade
Make the
guard will not hit the work clamp assembly.when
cutting miter and bevel cuts. Failure to heed this
warning could result in serious personal injury.
34