Table Extension - Craftsman 315.212240 Operator's Manual

TABLE EXTENSION
See Figures 41, 42, and 43.
The table extension can be used on either the right or
left side of your miter saw. To assemble and install
the table extension:
• Insert support rods into the two holes in the side of
the miter saw base. See Figure 42.
• Position table clamp bracket under miter saw base
between support rods and bottom of miter saw as
shown in figure 42.
Note: Support rods must extend through the
second set of holes in the miter saw base.
• Secure clamp bracket in place with the clamp
bracket screw. The clamp bracket screw threads
through the clamp bracket and tightens against the
bottom of the miter saw base.
• Slide the clamp support onto support rods and
secure using a phillips screw in each screw hole in
the top of the cramp support. See Figure 43.
• Place table extension on support rods.
• Slide square head bolt into middle slot then fit
extension clamp bracket over bolt. Tighten with
wing nut.
• Thread adjustment screws into support rods as
shown in figure 41.
PHILLIPS
SCREW
STOPBLOCK
KNOB CLAMP
SUPPORT
STOP
BLOCK
TABLE
TO Level the Miter Saw:
• Loosen wing nut.
• Place a level or cther straight object across the
miter saw base and table extension.
• Loosen or tighten the adjustment screws as
needed until the extension table is at the same
height and revel with the miter saw table.
• Retighten wing nut.
TABLE
CLAMP
BRACKET
CLAMP
BRACKET SCREW
SAWVIEWEDFROMBELOW Fig. 42
CARRIAGE
BOLT_
SUPPORT
ROD
\
_WING NUT
ADJUSTMENT
SCREW
MITER
SAWBASE
CLAMP
HEADBOLT BRACKETSCREW
SION
CLAMPBRACKET
Fig. 41
32