Craftsman 126.32565 Operator's Manual page 35

LOWER BLADE GUARD
,A WARNING I
Do not use the saw if the Lower Blade
Guard is damaged or not operating correctly.
A damaged or non-functioning guard
must be replaced before the saw is used.
A replacement guard must be tested for
efficient and safe procedure with the machine
disconnected from the power source. The
guard operates automatically as the Cutting
Head is raised or lowered.
The guard operating arm retaining screw and
pivot should be lubricated occasionally with
light machine oil. Check that the retaining
screw is securely tightened, especially after a
blade change.
Refer to INSTALLING OR REMOVING THE
BLADE section page 19.
DUST COLLECTION BAG
To maintain extraction efficiency empty
the Dust Collection Bag when it becomes
approximately 2/3 full. Dispose of the
contents in an environmentally responsible
manner. The bag has a side zip opening.
Do not use the bag when cutting metallic
materials.
LUBRICATION
All motor bearings in this tool are lubricated
with a sufficient amount of high grade
lubricant for the life of the unit under normal
operating conditions. No further lubrication is
required.
Lubricate the following as necessary:
Chop pivot (Fig. BB): Apply light machine
oil to the pivot bolt.
(Fig. BB)
Lower Guard Operating Arm (Fig. CC):
Apply light machine oil to the retaining screw
and pivot connection point of the operating
arm.
(Fig. CC)
35