Craftsman 536.249810 Operator's Manual page 8

ASSEMBLY
HOW TO ATTACH THE BAG MOUNTING PLATE
6x!10
15x85
(G)
15x79
Rear
Plate
(F)
Plastic Cover
(H)
740227
1. Attach two shoulder bolts (D) to the rear plate and secure
with nuts (E) (see Figure 5).
2. Remove the two screws located at the bottom of the rear
plate. Replace the screws with two double end studs (F)
and nuts (G). Make sure to assemble the short end of the
studs (F) to the rear plate.
3. Remove the plastic cover.
4. Align the slots in the bag mounting plate with the shoulder
bolts. Push the bag mounting plate down onto the shoul-
der bolts (see Figure 6).
5. Fasten the bottom of the bag mounting plate to the studs
with the knobs (H).
Shoulder
Bolts
Bag
Mounting
Plate
(H)
Studs
Figure 5
Figure 6
HOW TO ASSEMBLE THE BAG COVER
(L)
15x84
To attach the cover, slide the left pivot hole onto the left end
of the hinge rod. Slide the cover to the right (see Figure 7).
2. Slide the right pivot hole onto the right end of the hinge rod.
Side the cover to the left until it stops.
3. Slide the shoulder bolt (K) through the large loop in the tor-
sion spring. Then, slide the shoulder bolt (K) through the
mounting hole in the cover. Secure with the nut (L).
,_ WARNING: The torsion spring is spring loaded to
keep the cover closed. Use caution when attaching
the the torsion spring.
_L) Cove_rSion Sprin_
Left Pivot i'/%
Hole Hinge Rod
" Right Pivot Hole
Figure 7
F-020902L 8