Single Pythagorean Theorem Measurement Mode - Craftsman 320.48277 Owner's Manual

6 Press the Read key again
to display the width in the
second row of the screen
(Fig,. 16);
7. The height line in the
,,_t,, icon wiil start to blink
(Fig., 16)..
8., Press the Read key again
to display the volume in the
lowest row of the screen;
the height will be displayed
at the same time in the third
row of the screen (Fig. 17).
9. Press the Read key to make
a new measurement..
Single Pythagorean Theorem
measurement mode
The Pythagorean Theorem
measurement mode is used to
measure distances that cannot
be measured directly because
an obstacle would obstruct the
laser beam or no target surface
is available as a reflector.
Correct results are achieved
only when the laser beam and
the sought distance form a
precise right angle {90°).
In the illustrated example
(Fig. 18), the length BC is
the unknown distance to be
determined. For this purpose, AB
and AC must be measured.. AC
and BC must form a right angle.
1. Press the Mode key
"1_ "to choose single
Pythagorean Theorem
measurement
mode (Fig., 19)..
2.. The blinking line in "1___"
indicates the distance AB to
be measured.
Fig. 16
F ",
Fig
Fig
Fig.. 19
f
_ o o m _ _
A
48277 ManuaLRevlsed_09-0211 Page 14