To Change The Units; To Take Measurements; Clear Function - Craftsman 320.48277 Owner's Manual

To change the units
Press unit conversion key ,,_mJ,, to change the units among decimal units of
feet, 1/16-in. increments, decimal units of inches, 1/16qn increments of inches,
meters and millimeters as shown below.
Setting Distance
decimal units of feet feet (decimal)
I/16-in. increments feet & 1/16inch
decimal units of inches Inches (decimal)
1/16-in. increments of inches inches & 1/16inch
meters meters
millimeters millimeters
Area
feet 2
feet =
feet _
feet 2
Volume
feet 3
feeP
feet 3
feet 3
m 2 m=
m 2 m3
To take measurements
NOTE: The laser will switch off after 20 seconds of inactivity, if a measurement
has not been made within the previous 20 seconds, push READ key "_"
again to turn on the laser.
_k WARNING: Do not point the laser dot at persons or animals and do not
stare into the laser' beam or view directly with optical instruments_
Clear function
Push the Clear key "_L_" to erase the current measurement and display the
previous measurement..
48277 Manual_Revised_09_0211 Page 10