KitchenAid KSSS36MDX05 Installation Instructions Manual page 10

15
. Assemble the bottom trim of
the top grille onto the trim at the top of
the cabinet.
top qrille
mounting brackets
.
16
Use the four sheet metal
. screws to attach top grille to the
mounting brackets on top of the
cabinet.
top grille decorative
panel
17
. Remove screws and side trim
from one side of the decorative panel.
Insert your panel. Reattach side trim
and screws.
18
. Slide decorative panel down to
reattach to top grille.
19
. If side panels are not used,
go to Step 20. '
If built-in area depth is 25"
(63.5 cm) or more, side panels can be
installed inside the side trim or attached
to the outside of the side trim.
Top
view
l
Inside side trim piece: Slide front
edge of routed side panel into trim
piece. Nail rear edge of panel to
NOTE: KitchenAid is not responsible
for the removal of molding or
support board.
decorative panels that would prevent
the refrigerator from being serviced.
Lot-tom grille
20
Open appliance doors and
. remove protective film from
door frame. Recheck water connections
at bottom of refrigerator for leaks.
Attach bottom grille to cabinet with
two screws. Install shelves and bins in
refrigerator and freezer compartments.
21
Set refrigerator and freezer
midpoint between "COLD" and
. compartment controls to the
"COLDEST." Check that the compressor
is operating properly and that all five
lights are working.
Part No. 2004864 Rev. A
0 1997 KitchenAid.
8 Registered trademark
of KitchenAid, U.S.A.
UCtchenAid"
E APPLIANCE
Prepared by KitchenAid, Benton Harbor, Michigan 49022
Printed in U.S.A.