Operation; Applications; Battery Protection Features; Installing Battery Pack - Craftsman 315.114261 Operator's Manual

5-1/2 in, 19.2 volt cordless trim saw
Hide thumbs Also See for 315.114261:
Table of Contents

Advertisement

A
A
WARNING:
Do not allow familiarity with tools to
make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious
injury.
WARNING:
Always wear safety goggles or safety
glasses with side shields when operating tools.
Failure to do so could result in objects being thrown
into your eyes, resulting in possible serious injury.
APPLICATIONS
You may use this tool for the following purposes:
[] Cutting all types of wood products (lumber, plywood,
paneling).
This product will accept DieHardo 19.2 V lithium-ion bat-
tery packs and Craftsman 19.2 V nickel-cadmium
battery
packs.
For complete charging instructions, refer to the Operator's
Manual for the battery packs and chargers listed in the
General Safety Rules.
BATTERY
PROTECTION
FEATURES
DieHardo 19.2 V lithium-ion battery packs are designed
with features that protect the lithium-ion cells and
maximize battery life.
If the tool stops during use, release the trigger to reset
and resume operation. If the tool still does not work, the
battery needs to be recharged.
INSTALLING
BATTERY
PACK
See Figure 5.
NOTE: Battery pack is shipped in a low charge condition.
Therefore, it must be charged prior to use. Refer to
"CHARGING
BATTERY PACK" for charging instructions.
[] Place battery pack in your saw. Align raised rib on
battery pack with groove inside saw, then slide battery
pack in saw as shown in figure 5.
[] Make sure the latches on each side of your battery
pack snap into place and battery pack is secured in
saw before beginning operation.
LATCHES
BATTERYPACK
Fig. 5
,_,
CAUTION:
When placing battery pack in your saw,
be sure raised rib on battery pack aligns with groove
inside saw and latches snap into place properly.
Improper assembly can cause damage to saw and
battery pack.
REMOVING
BATTERY
PACK
See Figure 6.
[] Locate latches on side of battery pack and depress to
release battery pack from your saw.
[] Remove battery pack from your saw.
!!
TO
REMOVE
DEPRESSLATCHES TO
BATTERY PACK-_
IN_TOALL
BATTERY PACK
Fig. 6
12

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents