Table of Contents
Advertisement
WIDTHOF
CUT SCALE
See Figure 13.
A width of cut scale has been provided on the base of
the saw. When making straight cross cuts or rip cuts, the
scale can be used to measure up to four inches to the
right side of the blade. It can be used to measure up to
one inch to the left side of the blade.
ADJUST(NG
BLADE
DEPTH
See Figure 14.
Always keep correct blade depth setting. The correct
blade depth setting for all cuts should not exceed 1/4 in.
below the material being cut. More blade depth will
increase the chance of kickback and cause the cut to be
rough. For more depth of cut accuracy, a scale is located
on the upper blade guard.
[] Remove battery pack from saw.
[] Loosen depth adjustment knob.
[] Determine the desired depth of cut.
[] Locate depth of cut scale on back of upper blade
guard.
[] Hold base flat against the workpiece and raise or lower
saw until the indicator mark on bracket aligns with
notch on blade guard.
[] Tighten depth adjustment knob securely.
BASE
ASSEMBLY
WIDTH OF
CUTSCALE
TO RAISE
SAW
BLADE
Fig. 13
TO
LOWERSAW
TO
LOOSEN
DEPTH
ADJUSTMENT
KNOB
BASE
ASSEMBLY
TO
TIGHTEN
Fig. 14
15
Hide quick links:
Advertisement
Table of Contents
