Table of Contents
Advertisement
REMOV(NGBLADE
See Figure 3.
[] Remove battery pack from saw.
[] Remove blade wrench from storage area.
[] Position saw as shown in figure 3, depress spindle lock
button, and remove blade screw.
NOTE: Turn blade screw clockwise to remove.
[] Remove outer blade washer.
NOTE: Blade can be removed at this point.
_
WARN(NG:
Do not use any attachments or ac-
cessories not recommended
by the manufacturer
of this tool. The use of attachments
or accessories
not recommended
can result in serious personal
injury.
EDGE GU(DE
Use the edge guide provided with your saw when mak-
ing wide rip cuts. A five inch scale has been provided on
the edge guide. When using the width of cut scale on the
base in combination
with the edge guide, cuts can be
made up to 6 in. to the left of the edge guide or 8-7/8 in.
to the right of the edge guide.
The edge guide helps prevent the blade from twisting in a
cut. The blade twisting in a cut can cause kickback.
(NSTALL(NG
EDGE GUIDE
See Figure 4.
[] Remove battery pack from saw.
_,
WARNING:
Failure to remove battery pack from
saw could result in accidental starting causing
possible serious personal injury.
[] Place edge guide through holes in saw base.
[] Adjust edge guide to the width needed.
[] Tighten edge guide screw (wing screw) securely.
When using an edge guide, position the face of the edge
guide firmly against the edge of workpiece. This makes for
a true cut without pinching the blade. The guiding edge of
workpiece must be straight for your cut to be straight. Use
caution to prevent the blade from binding in the cut.
DEPRESS SPINDLE
LOCKBUTTON
TO
LOOSEN
\
\
RIP
GUIDESCREW
(WING SCREW)
TO
TIGHTEN
BLADE
WRENCH
BLADE
SCREW
Fig. 3
RiP GUIDE
(EDGEGUIDE)
PLACERIP
GUIDETHRU ROLES
Fig. 4
11
Hide quick links:
Advertisement
Table of Contents
