Advertisement
UNPACKING
AND PREASSEMBLY
WARNING: To avoid injury from unexpected start-
ing or electrical shock, do not plug the power cord
into a source
of power during unpacking
and
assembly.
This cord must remain
unplugged
whenever you are working on the saw.
2. Place the saw on a secure stationary work surface
and look the saw over carefully.
Model 113.234600 is shipped complete in one box.
WARNING: Although small, this saw is heavy. To
avoid back injury, get help whenever you have to
ft the saw more than 10 inches.
1. Remove the miter saw from the carton by lifting the
saw by the base.
WARNING: If any part is missing or damaged, do
not plug the saw in until the missing or damaged
part is correctly replaced. To avoid electric shock,
use only identical replacement parts when servic-
ing doub e nsu ated tools.
tools needed
Tools required
for assembly
and alignment
of Miter Saw:
•
Medium
Screwdriver
• #2 Phillips
Screwdriver
• Combination
Square
•
':_ Box End/Open
End Wrench
or Socket
• 2 - 1_6 Box End/Open
End Wrenches
or Adjustable
Wrenches
or Socket
Wrenches
• -%6" Hex "L:' Wrench
MEDIUM
SCREWDRIVER
#2 PHILLIPS SCREWDRIVER
COMBINATION
SQUARE
MUST BE TRUE
DRAW
LIGHT
STRAIGHT
EDGE
OF
LINE
ON BOARD
BOARD
3t4"
THICK
EDGE_
_',_ .A
THIS EDGE MUST BE
ALONG
THIS
\
.-;
7t')3_,P, ./
PERFECTLY
STRAIGHT
SHOULD
BE NO GAP OR OVERLAP
WHEN
SQUARE
IS FLIPPED
OVER
IN DOTTED
POSITION
1/2"WRENCH
Wld' BOX END/OPEN END
WRENCHES
ADJUSTABLE WRENCH
I_"SOCKET
COMBINATION
SQUARE
1%d'SOCKETS
&
SOCKET
WRENCHES
%d' HEX "L' WRENCH
€_
c_
oz. _,,)
Advertisement
