Initialization Of The Microprocessor - Denon AVR-982 Operating Instructions Manual

• TO call out out preset stations from the remote control unit.
Watching the display, press the
SH_T SHIFT button to select the preset
memory block.
{Remote control unit}
(z3
CHANNEL
Watching the display, press the
CHANNEL + (UP) or - (DOWN)
button to select the desired preset
channel.
{Remote control unit}
• Calling out preset stations from the main unit's panel.
TUNING Press the TUNING PRESET button.
PRESET
{Main unitl
...... Turn the FUNCTION knob and
[O _ so lect the desired station.
{Main unit)
1
2
_"'_ _. '_
o 0 0 0
1 2
,Ot
BLAST FUNCTION MEMORY
• This unit is eq@pped with a last function memory which stores the input and output setting conditions as they were immediately before the
power is switched off.
This function eliminates the need to perform complicated resettings when the power is switched on.
• The unit is also equipped with a back-up memory. This function provides approximately one week of memory storage when the main unit's
power switch is off and with the power cord disconnected.
[] INITIALIZATION OF THE MICROPROCESSOR
When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the
microprocessor is required by the following procedure.
Switch off the unit and remove the AC cord from the wall
outlet.
Hold the following A button and B button, and plug the AC
cord into the outlet.
Check that the entire display is flashing with an interval of
about 1 second, and release your fingers from the 2 buttons
and the microprocessor will be initialized.
NOTES:
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the button settings are
reset to the default values (the values set upon shipment from
the factory).
O[::: ]
@ o o o
= Z
6 o
ZOZ
2