Delta BS150LS Instruction Manual page 10

4. Re-assemble the locking lever stud (G)Fig. 12
throughthe trunnionslot (L)andtightenwith the
tablelocking leverhandle (seeinset).
5. Fig.13 showsthe tablelockingleverdisassembled
(removed i n STEP1).Item(B)is a M10flatwasher,
(G)stud,(A)LockingLever, ( E)spring, ( D)shoulder
screw, a nd(C)4mmhexwrench.
6. Re-assemble thescrew(D)Fig.13A andtightenusing
4mmhexwrench provided.
7.
8.
Fig. 13
Fig. 14 shows the disassembled table tilt pinion knob
(N), spring (O), and special screw (P), removed in
STEP 1.
Re-assemble the table tilt pinion knob (N) Fig.
15, on the back of saw so that the teeth on the
pinion knob (N) engage the teeth on the trunnion
(R). Fasten in place with the special screw (P) and
spring using the 4mm wrench provided.
Fig. 12
Fig. 13A
N
Fig.14
10
Fig.15