Delta BS150LS Instruction Manual page 11

9. Loosen thescrew(T)Fig.16andalignpointer ( S)with
"0"mark onthetrunnion scale(M). T ighten securely.
NOTE: M akesuretableissetat 90degrees tothe blade
or checkthe pointeralignment afteradjusting the table
stops(seesection"ADJUSTING
THE TABLE POSiTiVE
STOPS").
10. Re-assemble the screw (W) Fig. 17 that was removed
in STEP 2, down through hole in table. Place the M6
flat washer (Z) on the M6 x 30mm screw, then thread
the M6 wing nut (X) on the screw (W) and tighten
securely.
Fig.16
ATTACHING LAMP TO MACHINE
1.
Fasten the lamp bracket (A) Fig. 18 to the top cover
of the machine, using two M6 x 20mm socket head
nylock screws (B) and M6 Iockwashers. Tighten
securely using the 5mm hex wrench provided.
2.
Peel the backing from the cord clamps (C) Fig. 19,
and apply one clamp at each of the locations shown.
Make certain the lamp cord is routed out of the way
of the blade, then secure the cord (D)to the cord
clamps (C) Fig. 19.
3. The flexible lamp operates independently of the band
saw. To turn the lamp on and off, rotate the switch
(E) Fig. 19.
To reduce the risk of fire, use 40 watt (or
less), 120 volt, reflector track type light
bulb (not supplied). A standard household light bulb
should not be used. The reflector track type light bulb
should not extend below the lamp shade.
Fig. 17
Fig. 18
Fig. 19
11