Oki C9800hdn Software Installation Manual page 3

Network Installation
Windows (cont'd)
2 Connect the Ethernet Interface
1. Switch off the printer and computer.
2. Remove the protective cover from the network connector on
the printer.
3. Connect the Ethernet cable between the print and the
Ethernet hub.
For more information, see the Configuration Guide on the
User Documentation CD.
NOTE
3 Assign an IP address to the printer
If you are not using DHCP, you need to obtain an IP Address
from your network Administrator and enter it using the front
panel:
1. Confirm that the printer displays [ Ready to print ].
∇
key until [ Admin Setup ] appears. Press the Enter
2. Press
key.
3. Continue to Setup ? displays. Press
printer goes offline and Running Setup displays. This will
take about a minute.
4. The Setup Menu displays, press
ENTER
Press .
∇
to select Protocol Setup . Press
5. Press
∇
to select TCP/IP Setup . Press
6. Press
∇
to select Ethernet Setup . Press
7. Press
8. TCP/IP Ethernet displays. Select Yes and press
Enable AutoIP Config?
9. The default IP Address displays. Use
ENTER
octet. Press
the octet unchanged.
10. Subnet Mask displays. Repeat instructions in step 9.
11. TCP/IP bound to Ethernet displays. Press
12. Gateway Address displays. Repeat instructions in step 9.
ENTER
13. Press to exit TCP/IP Setup, Protocol Setup, and
Network Setup.
14. Select Yes and press
ENTER
to Exit the Setup Menu.
15. Printer restarts the server and initializes. Ready to Print
displays.
3
ENTER
to select Yes . The
∇
to select Network Setup .
ENTER
ENTER
.
ENTER
ENTER
displays. Select No . Press
∆ ∇
or to change each
to proceed to the next octet or to leave
ENTER
ENTER
to Save Changes. Press
.
.
.
ENTER
.
.