Parallel Connection - Oki C9800hdn Software Installation Manual

Windows Installation
®

Parallel Connection

1 Connect the parallel Interface
For direct connection to a PC
This port requires a bi-directional (IEEE 1284 compliant)
parallel cable. Cable must be shielded and UL and CSA
approved.
1. Make sure the printer is powered off.
2. Connect a parallel cable between the printer and computer.
2 Install the Fiery PostScript Printer
Driver
The installation procedure may vary slightly depending on the
operating system you are using. Drivers are provided for
®
Windows XP, 2000, Me, and NT 4.0.
1. Make sure the cable is connected to your printer and PC and
your printer is turned OFF.
2. Insert the driver CD (CD1) supplied with your printer into
your CD-ROM drive. The CD will autorun.
If it doesn't autorun, click Start
Browse to your CD-ROM drive. Double-click
OK
Click .
3. Select your language.
4. The License Agreement appears. Click Next to accept.
Custom Install
5. Select
installed with the printer driver. To install only the printer
driver, select Minimal Install
6. The Software Installation screen appears. Click the
Driver Installer
Local printer
7. Click
8. Select the LPT1 port. Click
9. Select your printer model.
10. Select the PS (PostScript) printer emulation. Click
11. If prompted, type a printer name for your printer. Click
Next
.
12. If prompted, select "do not share this printer." Click
13. Follow the on-screen instructions to compete the
installation. Click
14. Switch the printer
To print a test page:
→
Start Settings
15. Click
11
NOTE
→ →
Run
to select software tools to be
and skip the next step.
button.
Next
. Click .
Next .
Finish
.
ON
.
→
Printers
.
Browse.
Install.exe
.
Printer
Next
.
Next
.