HP Surestore Disk Array 12h - And FC60 Installation Manual page 21

or, inside the HP firewall (HP-qualified personnel only):
http://essd.boi.hp.com
click on "Products"
click on "Disk Arrays"
click on "Disk Array 12H"
click on "AutoRAID firmware"
left click on "ARDlif_HPxx" (xx = the controller firmware revision you want to download)
save the file using "save as" to your system
Once you have the ARDlif file, copy it to a tape using the following command:
dd if=ARDlif of=/dev/rmt/{tapedrive} bs=2k
2. On the machine you want to download and while the operating system is running get the following
information:
Perform an "ioscan -fnCdisk" and "ioscan –fnCtape" to locate the arrays and the tape device and note their
location.
Tape device hardware address
Tape device location (i.e., /dev/rmt/...):
Disk array(s) bus number(s):
Firmware file name needed to download
(This file should be in the ARDlif file)
Primary controller
_________________________________________
_________________________________________
_________________________________________
_________________________________________
_________________________________________
21