HP Surestore 6164 - Switch Quick Start Manual page 30

30
e. Carefully position the plenum top panel over the side panels so that
the folded ends of the top panel face down and are outside of the side
panels.
f. With the top panel aligned with the side panels, press one of the side
panels firmly against the inner surface of the folded end of the top
panel to ensure that the adhesive strip on the side panel makes full
contact with the folded end of the top panel. Repeat this step for the
other side panel.
17.Install the plenum in the rack:
a. Remove the paper backing from the two adhesive strips on the bottom
surface of the plenum.
b. Position the plenum against the back of the switch and slide it down
until the adhesive strips on the underside of the plenum contact the
shim plates that are on top of the rail tray (see
Figure 17. Inserting the Plenum
c. Press down firmly on the bottom panel of the plenum above the
adhesive strips to ensure that the adhesive strips make full contact with
the shim plates on top of the rail tray.
Figure 17).
Quick Start Guide