HP Surestore 6164 - Switch Quick Start Manual page 29

Installing the Switch
15.Fully tighten the screws that attach the rack-mount bracket adjustable
plates to rack uprights, then fully tighten the screws that attach the
adjustable plates to the stationary plates and the screws that attach the
stationary plates to the switch chassis (see
16.Assemble the plenum:
a. Position the bottom panel of the plenum on a flat surface with the two
folded ends facing up (see
Figure 16. Assembling the Plenum
b. Remove the paper backing from one of the adhesive strips on one of
the plenum side panels, and carefully position the side panel against
the inner surface of one of the folded ends of the bottom panel (see
Figure 16). Press the side panel firmly against the upright end of the
bottom panel to ensure that the adhesive strip on the side panel makes
full contact with the end of the bottom panel. You can use a screwdriver
handle to increase the pressure you apply when joining the parts.
c. Repeat Step 16b
d. Remove the paper backing from the adhesive strips on the upper ends
of both plenum side panels.
Figure 16).
for the other side panel.
Figure 14).
29