HP StorageWorks P9000 - Disk Arrays User Manual page 41

Table 17 RAID Manager Errors Related to Manual Migration Plans (continued)
Error Code Message
(SSB2)
2039 The migration source volume is a quorum disk.
203a The migration target volume is a quorum disk.
204A The current microcode does not support the
capacity of the migration source volume.
204B The current microcode does not support the
capacity of the migration source volume.
2055 The migration target volume is being used with
Continuous Access Journal.
2056 The migration source volume is being used with
Continuous Access Journal.
2058 The migration target volume and the migration
source volume belong to the same parity group.
205A The migration source volume is being shredded.
205C The migration target volume is being used with
Continuous Access Journal.
2075 The migration source volume corresponds to either
of the following causes:
1. The volume is P-VOL of the Snapshot pair. The
pair is not in PAIR status.
2. The volume is S-VOL of the Snapshot pair or
V-VOL of Snapshot.
2076 The migration target volume corresponds to either
of the following causes:
1. The volume is P-VOL of the Snapshot pair.
2. The volume is S-VOL of the Snapshot pair or
V-VOL of Snapshot.
2078 The migration source volume is the pool-VOL of
Snapshot.
2079 The migration target volume is the pool-VOL of
Snapshot.
2089 The migration source volume is undergoing quick
formatting.
208A The migration target volume is undergoing quick
formatting.
2090 The migration target volume is the Thin
Provisioning or Smart Tiers virtual volume which
is not associated with a pool.
2091 The migration source volume is the Thin
Provisioning or Smart Tiers virtual volume which
is not associated with a pool.
Required Action
The volume cannot be migrated. Check the
configuration definition file
The volume cannot be migrated. Check the
configuration definition file.
Specify a volume whose capacity is supported.
Specify a volume whose capacity is supported.
Release the volume from Continuous Access
Journal, and then migrate the volume.
Release the volume from Continuous Access
Journal, and then migrate the volume.
The source volume and target volume cannot
belong to the same parity group. Select a source
volume and target volume from different parity
groups.
Wait for the shredding operation to complete and
then migrate the volume.
Release the volume from Continuous Access
Journal, and then migrate the volume.
Perform the following actions for each cause:
1. Change the Snapshot pair status to PAIR, and
then migrate the volume.
2. None. This migration plan cannot be executed.
Perform the following actions for each cause:
1. Release the Snapshot pair, and then migrate
the volume.
2. None. This migration plan cannot be executed.
Release the pool-VOL setting of Snapshot from the
volume, and then migrate the volume.
Release the pool-VOL setting of Snapshot from the
volume, and then migrate the volume.
Wait for the quick formatting to complete and then
migrate the volume.
Wait for the quick formatting to complete and then
migrate the volume.
Associate the Thin Provisioning or Smart Tiers
virtual volume with a pool, and then migrate the
volume.
Associate the Thin Provisioning or Smart Tiers
virtual volume with a pool, and then migrate the
volume.
Troubleshooting when using RAID Manager 41