HP StorageWorks P2000 - G3 MSA Array Systems Installation Instructions page 2

The following illustration shows controller locations:
1. Controller module A
Enabling Partner Firmware Upgrade
(dual-controller configurations only)
In a dual-controller configuration, the Partner Firmware Upgrade option
ensures that both controllers have the most recent version. HP
recommends enabling this feature.
To see the current Partner Firmware Upgrade setting, select the array in
the navigation tree and then select Tools>Advanced Settings>Firmware.
If needed, check the box and click Apply to enable the new setting.
NOTE:
If the Tools>Advanced Settings>Firmware page is not
accessible, log in as an Advanced or Diagnostic level user.
Removing the air management module
IMPORTANT:
Remove the air management module from the bottom bay only
when installing an optional second module.
1. Turn the thumbscrews until they disengage from the module (1) and
rotate both latches downward to disengage the module from the
internal connector (2).
2. Pull the module straight out of the enclosure (3).
2. Controller module B
Installing the new module
IMPORTANT:
When installing modules in a new system, install the first module
in the top bay.
1. With the latches in the open position, slide the module into the
enclosure as far as it will go (1). If necessary, press lightly on the
top-center of the module to facilitate insertion.
2. Rotate the latches upward to engage the module with the internal
connector (2) and then, turn the thumbscrews finger-tight (3).
NOTE:
For clarity, only relevant details are shown in these
illustrations. Port and LED information is not included.
After installing a second controller in an operational single-controller
system, the new controller automatically begins to initialize. If the
firmware versions differ between the two controllers, Partner Firmware
Upgrade feature brings the older firmware to the later firmware level.
Page 2