Image 10.6 Owner's Manual page 5

ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until the treadmill is fully assembled.
Assembly can be completed using the Included 7/32" ellen wrench _.
1. Find the Right Updght (15), which contains the Upright Wire
Harness (12) (see the Inset drawing). Hold an Updght Spacer
(25) inside the lower end of the Right UprighL Insed a 3/8" x
3 1/2" Bolt (27), with one of the four Updght Washers (26), into
the lower hole In the Right Updght, and through the Updght
Spacer. Slide a Star Washer (49) onto the Boll Finger tighten
the Bolt into the indicated hole In the Frame (50).
Insert a3/8" x 3 1/2" Bolt (27), with an Upright Washer (26),
through the other hole In the lower end of the Right Upright (15).
Finger tighten the Bolt into the Frame (50).
Attach the Left Upright (not shown) in the same manner.
25 26_27
2. Hold the right end of the Console Crossbar (6) near the Right
•Updght (15). Connect the Console Wire Hamess (10) to the
Updght Wire _amesa (12). The small latch on the Console
Wire Harness should snap onto the Updght Wire Harness (see
the inset drawing). If the Wire Harnesses do not fit together
easily, turn them; do not force the Wire Hamesses together.
•Slide the ends of the 6" Cable Looms (30) againstthe ends of
the wire Harnesses (10, 12). insed the Cable Looms into the
Right Updght (15). Be careful not to damage the Wire
Harnesses.
3. Slide the ends Of the Console Crossbar (6) into the Right and
Left Updghts (15, 2) as shown. Insed a Console Knob (3) into
each Upright, and thread the Console Knobs into the ends of
the Console Crossbar. Rotste the Console (9) to the desired
angte, and tighten the Console Knobs.
4. Tap an Upright Endcap (4) into each of the Uprights (15, 2).
See assembly step 1. Using t_e Included 7/32 =allen wrench,
tighten the four 3/8" x 3 1/2= Bolts (27).
12
30
4
15