Nikon COOLPIX L100 User Manual page 135

If the camera fails to function as expected, check the list of common problems
below before c:onsuJting your retailer or Nikon-authorized service representative.
Refer to the page numbers in the right-most column for more information.
Display, Settings and Power Supply
Problem "_"w_÷ Cause/Solution _'_
Monitor is blank Camera is off. 20
20
15,24
31
66
Battery exhausted.
Standby mode for saving power: press the
shutter-release button halfway.
When flash lamp blinks red, wait until flash has
charged.
Camera and computer are connected via USB
cable.
Camera and TV are connected via AV cable.
Adjust monitor brightness.
Monitor is dirty. Clean monitor.
Battery exhausted.
Camera has turned offautomatically to save
power.
Battery is cold.
Pictures taken while tile clock is not set will
have a time stamp of %0/00/0000 00:00%
movies will be dated %1/01/200g 00:00." (Tile
"Date not set" indicator blinks during shooting
to indicate the clock is not set.) Set the correct
date and time using Date in the setup menu.
Check camera clock regularly against more
accurate timepieces and reset as required.
Hide info is selected for Photo info.
Select Show info.
Camera clock has not beet] set.
Date imprint is disabled in tile following
situations.
When scene mode is set to Museum or
Panorama assist.
When Continuous is set to Continuous or
BSS
When using sport continuous mode.
When recording movies.
Backup battery is exhausted; aH settings were
restored to their default values.
64
Monitor is hard to read gg
118
Camera turns offwithout 20
warning 105
118
Date and time of recording are 16
not correct
No indicators displayed in
monitor
Date imprint not available
Date not appearing on pictures
even when Date imprint is
enabled
Camera settings reset
96
99
16,96
41,43
83
48
61
r_
:3-
8
F
123