Table of Contents
Advertisement
O:NKYO
5.Ich Home
Theater Speaker Package
HTP-691
Make sure you have the following
accessories.
Front speakers (SKF-680)
08
Front speakers
Speaker cables 11 ft. (3.5 m)
20 rubber stoppersq
(For Front/Center/
Surround speakers)
"1 Configuration of the rubber stoppers may be different from the
figure, such as being 2 sheets instead of 1 sheet, but the total
number will be same.
Center speaker (SKC-680)
Center speaker
Speaker cable 10 ft. (3.0 m)
Surround speakers (SKR-680)
(Blue)
(Gray)
Surround speakers
Speaker cables 26 ft. (8.0 m)
Powered subwoofer (SKW-791)
Subwoofer
4 floor pads
RCA cable 10 ft. (3.0 m)
Keyhole slot
!_-
Speaker
terminals
SKF-680/SKR-680
Speaker terminals
SKC-680
Keyhole slots
• The front grilles are not designed to be removed so do not
attempt to remove them forcibly, as this will damage
them.
N Front
SKW-791
Status indicator
Off:
Subwoofer in standby mode or
disconnected
from power source
Blue: Subwoofer on
With the Auto Standby function, the
SKW-791 automatically
turns on when an
input signal is detected in standby mode.
When there's no input signal for a while,
the SKW-791 automatically enters
standby mode.
N Rear
i
--
OUTPUT LEVEL control
_
":::il
I
This control is used to adjust
volume of the subwoofer.
_
the
_SKW-791
This RGA input should be
To AC outlet
connected
to the subwoofer
pre
out on your AV receiver
with
supplied RCA cable.
• The Auto Standby
function
turns the subwoofer
on when the
input
signal exceeds
a certain
level. If the Auto Standby
function
does not work reliably,
try slightly
increasing
or decreasing
the
subwoofer
output
level on your receiver.
En-1
- Quick Links:
- Features
Hide quick links:
Advertisement
Table of Contents
