About Dts Signals - Onkyo HT-R758 Instruction Manual

m Only the front speakers produce sound
When the Stereo o1"Mono listening mode is selected, 36
only the front speakers and subwoofer produce
sound.
m Only the center speaker produces sound
ff you use the Dolby Pro Logic II Movie, Dolby Pro --
Logic II Music, or Dolby Pro Logic II Game listening
mode with a mono source, such as an AM radio
station or rnono TV program, the sound is
concentrated in the center speaker.
m The surround speakers produce no sound
When the T-D (Theater-Dimensional), Stereo o1"
Mono listening mode is selected, the surround
speakers produce no sound.
Make sure the speakers are configured correctly. 46
N The center speaker produces no sound
When the Stereo or Mono listening mode is selected, --
the center speaker produces no sound.
m The subwoofer produces no sound
When you play source material that contains no
information in the LFE channel, the subwoofer
produces no sound.
N There's no sound with a certain signal format
Check the digital audio output setting on the
connected device. On some game consoles, such as
those that support DVD, the default setting is off.
N
Depending on the input signal, some listening modes 33-37
cannot be selected.
Can't select the Pure Audio listening mode
(European and Australian models) The Pure Audio --
listening rnode cannot be selected while Zone 2 is on.
N Can't get 5.1 playback
N
Depending on the number of connected speakers, it is 33-37
not always possible to select all of the listening
modes.
The speaker volume cannot be set as required
After the volurne level of each individual speaker has 47
been adjusted, the maximum volume may be reduced.
N Noise can be heard
Using cable ties to bundle audio cables with power --
cords, speaker cables, and the like may degrade the
audio performance, so refrain from doing it.
N The Late Night function doesn't work
Make sure the source material is Dolby Digital,
Dolby Digital Plus, and Dolby TrueHD.
42
Appendix
N About DTS signals
When DTS program material ends and the DTS
bitstream stops, the AV receiver remains in DTS
listening mode and the tits indicator remains on. This
ix to prevent noise when you use the pause, fast
forward, or fast reverse function on your player. If
you switch your player from DTS to PCM, you may
not hear any sound because the AV receiver does not
switch formats immediately. [n such case, you should
stop your player for about three seconds and then
resume playback.
Ft
5 191
AV
gnaL
Playing DTS program material, using the pause, fast
forward, or fast reverse function on your player may
produce a short audible noise. This is not a
malfunction.
NThe beginning of audio received by an HDMI IN
can't be heard
Since it takes longer to identify the format of an
HDMI signal than it does for other digital audio
signals, audio output may not start immediately.
En-63 V
©©