Before Using The Home Theater Speaker Package; Using The Rubber Stoppers For A More Stable Platform; Using The Floor Pads For Subwoofer; Setting The Subwoofer Level - Onkyo HT-R591 Instruction Manual

m Front
Status indicator
Off: Subwoofer in standby mode or
disconnected from power source
Blue: Subwoofer on
With the Auto Standby function, the
SKW-591 automatically turns on when
an input signal is detected in standby
mode, When there's no input signal for
SKW-591 a while, the SKW-591 automatically
enters standby mode,
m Rear
(North American)
................................................................................ _ OUTPUT LEVEL control
I This control is used to the
adjust
_F7 i:_----J>_ volume of the subwoofer,
LINE INPUT
.................. This RCA input should be
To AC outlet connected to the subwoofer pre
out on your AV receiver with
supplied RCA cable,
(Asian) (Brazilian)
• The Auto Standby function turns the subwoofer on when the
input signal exceeds a certain level, ff the Auto Standby function
does not work reliably, try slightly increasing or decreasing the
subwoofer output level on your receiver.
Using the Rubber Stoppers for a More Stable
Platform
We recommend using the supplied rubber stoppers to
achieve the best possible sound from your speakers. The
rubber stoppers prevent the speakers from moving,
providing a more stable platform. Use rubber stoppers for
the center speaker.
_'-"-_ Rubber stoppers
/_'_ Bottom of the
SKC-591N/SKC-591
Using the Floor Pads for Subwoofer
If the subwoofer is placed on a hard floor (wood, vinyl,
tile, etc.) and playback is very loud, the subwoofer's feet
may damage the flooring. To prevent this, place the
supplied pads underneath the subwoofer's feet. The pads
also provide a stable base for the subwoofer.
Setting the Subwoofer Level
To set the level of the subwoofer, use the
OUTPUT LEVEL control. Set it so that bass
sounds are evenly balanced with the treble sounds _'_,u_'_
from the other speakers. Because our ears are less
sensitive to very low bass sounds, there's a temptation to
set the level of the subwoofer too high. As a rule of thumb,
set the subwoofer level to what you think is the optimal
level, and then back it off slightly.
Wall Mounting
To mount the front/surround/surround back speakers
vertically, use the keyhole slot shown to hang each speaker
on a screw that's securely screwed into the wall.
Keyhole slots for
wall mounting
SKF-591 SKR-590/SKB-590
To mount the center speaker horizontally, use the two
keyhole slots shown to hang the speaker on two screws that
are securely screwed into the wall.
Keyhole slots for wall mounting
SKC-591 N/
SKC-591
7-7/8" (200 mm)
• [f the center speaker is tilted, loosen the screw on the declined
side to move upward so that the speaker could be adjusted
vertically.
En-2