Table of Contents
Advertisement
15. Power Lines -- An outside antenna
system should
not be located in the vicinity of overhead
power
lines or other electric light or power circuits,
or
where it can fall into such power lines or circuits.
When installing
an outside
antenna
system,
extreme
care should
be taken to keep from
touching
such power lines or circuits
as contact
with them might be fetel.
16. Overloading
-- Do not overload wall outlets and
extension
cords as this can result in a risk of fire or
electric shock.
17. Objects and Liquids -- Never push objects of any
kind into this video unit through openings as they
may touch dangerous voltage points or short out
perts that could result in a fire or electric shock.
Never spill liquid of any kind onto the video unit.
18. Servicing
-- Do not attempt to service this video
unit yourself as opening or removing covers may
expose you to dangerous voltage or other hazards,
Refer ell servicing to qualified service personnel.
19. Damage Requiring
Service -- Unplug this video
unit from the wall outlet end refer servicing to
qualified service personnel under the following
conditions:
a. When the power-supply cord or plug is
damaged,
b. If any liquid has been spilled onto, or objects
have fellen into the video unit.
c. If the video unit has been exposed
to rain or
water.
d. If the video unit does not operate normally by
following
the operating
instructions.
Adjust only
those controls that are covered by the operating
instructions,
as an improper
adjustment
of other
controls may result in damage
and will often
require
extensive
work by e quelified
technicien
to restore
the video unit to its normel operetion.
e. If the video unit has been dropped or the cabinet
has been damaged.
f. When the video unit exhibits
e distinct change
in
performance
-- this indicates
a need for service.
20. Replacement
Perts -- When
replacement
parts are
required,
be sure the service technician
has used
replacement
parts specified
by the manufacturer
or
have the same characteristics es the original part.
Unauthorized
substitutions may result in fire,
electric shock or other hazards.
21. Safety Check--
Upon completion of any service or
repairs to this video unit, ask the service technician
to perform safety checks to determine that the
video unit is in safe operating order.
USE & LOCATION
• TO AVOID SHOCK HAZARD
... Your Camcorder
and power eul_y
should not be exposed to rain or moisture.
Do not connect the power supply or operate your Camcorder If it gets wet. Your Camcorder has been designed
for outdoor use, however it is not designed to sustain direct exposure to water, rain, sleet, snow, sand, dust, or a
direct splashing from a pool or even a cup of coffee. This action could permanently damage the internal
parts of
your Camcorder.
Do not attempt to disassemble this unit. There are no user serviceable
parts inside. Unplug
your Camcorder
from the power supply before cleaning.
• DO NOT AIM YOUR CAMCORDER
AT THE SUN OR OTHER BRIGHT OBJECTS
• DO NOT EXPOSE
YOUR CAMCORDER
TO EXTENDED
HIGH TEMPERATURE
... Such as, In direct sunlight,
inside a closed car, next to a heater, etc...
This action could permanently damage the internal parts of your
Camcorder.
• _/O_.ID
SUt)OEN
Ct'IAI_IIGES
tt4 "TEMPERA'T_RE
...
tf the
unit
_s suddent'#
moved
from
eL cold
_la.(_
to
e, w_.rm
place,
moisture
rna.y
IOrtTt
On the
tape
a.nd
inside
the
urt_t.
• DO
NOT
LEAVE
YOUR
CAMCORDER
OR
THE
POWER
SUPPLY
TURNED
ON
WHEN
NOT
IN
USE.
• STORAGE
OF YOUR CAMCORDER
,,. Store and handle your Camcorder
in a manner
thatwillnotsubject i t to
unnecessary movement (avoid shaking and striking). Your Camcorder
contains a sensitive pick-up device which
could be damaged by improper handling or storage.
CARE
• TO CLEAN YOUR CAMCORDER
... Do not use strong or abrasive
detergents when cleaning your Camcorder
body,
• TO PROTECT
THE LENS ..
Do not touch the surface of the lens with your hand. Use a commercial camcorder
lens solution and lens paper when cleaning the lens. Improper cleaning can scratch the lens coating.
• TO PROTECT
THE FINISH OF YOUR CAMCORDER
.., Before handling your Cemcorder,
make sure your
hands and face are free from any chemical products,
such as suntan lotion, as it may damage
the finish.
4
Hide quick links:
Advertisement
Table of Contents
