Intercharacter Delay - Welch Allyn IMAGETEAM 3800 User Manual

Some terminals drop information (characters) if data comes through too quickly.
Intercharacter, interfunction, and intermessage delays slow the transmission of
data, which increases data integrity.
Each delay is composed of a 5 millisecond step. You can program up to 99
steps (of 5 ms each).
This is a delay of up to 495 milliseconds (in multiples of 5) placed between the
transmission of each character of scanned data. You can program up to 99
steps (of 5 ms each). Scan the Intercharacter Delay bar code below, then scan
the number of steps, and the SAVE bar code from the inside back cover.
Note: If you make an error while scanning the digits (before scanning
Save), scan Discard on the back cover, scan the Intercharacter
Delay bar code, scan the correct digits, and Save again.
Prefix

Intercharacter Delay

To remove this delay, scan the Intercharacter Delay bar code, then set the
number of steps to 00. Scan the SAVE bar code from the inside back cover.
IMAGETEAM 3800 User's Guide
Scanned Data Suffix
1 2 3 4 5
Intercharacter Delay
4–7