Advertisement
Available languages
Available languages
PROBLEM
Compressor is
not supplying
enough air
to operate
accessories
CAUSE
Prolonged excessive use
of air.
Compressor is not large
enough for air requirement.
Hole in hose.
Check valve restricted.
Air leaks.
Restricted air intake filter.
Loose belt.
Restricted air
Dirty air filter.
intake
Motor will not
Motor overload protection
run
switch has tripped.
Tank pressure exceeds
_ressure switch "cut-in"
3ressure.
Check valve stuck open.
Loose electrical
connections.
Possible defective motor or
starting capacitor.
Paint spray on internal
motor parts.
Pressure release valve on
3ressure switch has not
Jnloaded head pressure.
CORRECTION
Decrease amount of air usage.
Check the accessory air requirement.
If it is higher than the SCFM or
)ressure supplied by your air
compressor, you need a larger
compressor.
Check and replace if required.
Remove and clean, or replace.
Tighten fittings.
Clean or replace air intake filter. Do
not operate the air compressor with
the filter removed. Refer to the "Air
Filter" paragraph in the Maintenance
section.
Loosen wingnut and then tighten
wingnut until it contacts the washer,
)lus one turn.
Clean or replace. See Air Filter
paragraph in the Maintenance
section.
Refer to "Motor Overload Protection"
under Operation. If motor overload
)rotection trips frequently, contact a
Trained Service Technician
Motor will start automatically when
tank pressure drops below "cut-in"
)ressure of pressure switch.
Remove and clean, or replace.
Check wiring connection inside
)ressure switch and terminal box
area.
Have checked by a Trained Service
Technician.
Have checked by a Trained Service
Technician. Do not operate the
compressor in the paint spray area.
See flammable vapor warning.
Bleed the line by pushing the lever
on the pressure switch to the "Off"
_osition; if the valve does not open,
replace switch.
25- ENG
N000578
Advertisement
