G Lossary; Accessories; Assembly; Contents Of Carton - Craftsman 919.167780 Operator's Manual

Become familiar with these terms before operating the
unit.
CFM: Cubic feet per minute.
SCFM: Standard cubic feet per minute; a unit of
measure of air delivery.
PSIG: Pounds per square inch gauge; a unit of meas-
ure of pressure.
ASME: American Society of Mechanical Engineers;
made, tested, inspected and registered to meet the
standards of the ASME.
Code Certification: Products that bear one or more
of the following marks: UL, CUL, ETL, CETL, have
been evaluated by OSHA certified independent safety
laboratories and meet the applicable Underwriters
Laboratories Standards for Safety.
Cut-in Pressure: While the motor is off, air tank
pressure drops as you continue to use your accesso-
ry. When the tank pressure drops to the factory set
low pressure the motor will restart automatically. The
low pressure at which the motor automatically restarts
is called "cut-in" pressure.
Cut-Out Pressure: When an air compressor is
turned on and begins to run, air pressure in the air
tank begins to build. It builds to a factory set high
pressure before the motor automatically shuts off -
protecting your air tank from pressure higher than its
capacity. The high pressure at which the motor shuts
off is called "cut-out" pressure.
Branch Circuit: Circuit carrying electricity from elec-
trical panel to outlet.
This unit is capable of powering the following Accessories. The accessories are available through the current
Power and Hand Tool Catalog or full-line Sears stores.
Accessories • Caulk Gun • 1/2" Ratchet • Reciprocating Saw
In Line Filter • Engine Cleaner • 3/8" Ratchet • Nibbler
Tire Air Chuck • Sand Blaster • 1/4" Ratchet
Spray Painting
• Quick Connector Sets Carpentry Tools Material Shaping • Multi-Purpose Spray
(various sizes) • Finishing Nailer / Stapler • 2.625" Hammer Gun
Air Pressure Regulators • Construction Nailer / • 1.625" Hammer • Automotive Spray Gun
Oil Fog Lubricators Stapler • 1/2" Drill • HVLP Spray Gun
• Air Hose:
Socket Driving
• 3/8" Drill
Finishing/Sanding
1/4", 3/8" or 1/2" I.D. • 1" Impact Wrench • High Speed Rotary • High Speed Sander
in various lengths • 3/4" Impact Wrench • Mini High Speed Rotary • Random Orbit Sander
Specialty Tools • 1/2" Impact Wrench • Cut-Off Tool • 6" DA Sander
Inflating/Blow Gun • 3/8" Impact/Butterfly • Shear • Jitterbug Sander
Grease Gun Wrench • 4" Angle Grinder • Straight Line Sander
Contents of Carton
1 - Air Compressor
2- Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
2 - Rubber Bumpers
2- Screws, 1/4-20 x .75
Tools Required for Assembly
1 - 9/16" socket or open end wrench
1 - 1/2" socket or open end wrench
7 - ENG D22130