G Lossary; Accessories; Assembly; Contents Of Carton - Craftsman 919.167240 Operator's Manual

Become familiar with these terms before operating the
unit.
CFM: Cubic feet per minute.
SCFM: Standard cubic feet per minute; a unit of
measure of air delivery.
PSIG: Pounds per square inch gauge; a unit of meas-
ure of pressure.
ASME: American Society of Mechanical Engineers;
made, tested, inspected and registered to meet the
standards of the ASME.
Code Certification: Products that bear one or more
of the following marks: UL, CUL, ETL, CETL, have
been evaluated by OSHA certified independent safety
laboratories and meet the applicable Underwriters
Laboratories Standards for Safety.
Cut-In Pressure: While the motor is off, air tank
pressure drops as you continue to use your accesso-
ry. When the tank pressure drops to a certain low
level the motor will restart automatically. The low
pressure at which the motor automatically restarts is
called "cut-in" pressure.
Cut-Out Pressure: When an air compressor is
turned on and begins to run, air pressure in the air
tank begins to build. It builds to a certain high pres-
sure before the motor automatically shuts off - pro-
tecting your air tank from pressure higher than its
capacity. The high pressure at which the motor shuts
off is called "cut-out" pressure.
Branch Circuit: Circuit carrying electricity from elec-
trical panel to outlet.
This unit is capable of powering the following Accessories. The accessories are available through the current
Power and Hand Tool Catalog or full-line Sears stores.
Accessories
Specialty
Tools Socket
Driving Spray Painting
• In Line Filter • Air Brush • 1/2" Impact Wrench • Multi-Purpose Spray
• Tire Air Chuck • Inflating/Blow Gun • 3/8" Impact/Butterfly Gun
Quick Connector Sets • Grease Gun Wrench • Automotive Spray Gun
(various sizes) • Caulk Gun • 3/8" Ratchet • HVLP Spray Gun
Air Pressure Regulators • Engine Cleaner • 1/4" Ratchet
Finishing
/ Sanding
Oil Fog Lubricators Sand Blaster Material Shaping • Jitterbug Sander
Air Hose: Carpentry Tools • 2.625" Hammer • Straight Line Sander
1/4", 3/8" OR 1/2" I.D. _ Finishing Nailer/Stapler _ 1.625" Hammer
in various lengths • Construction Nailer / • 3/8" Drill
Stapler • Mini High Speed Rotary
Reciprocating Saw
Nibbler
Contents of Carton
1 - Air Compressor
2- Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
2 - Molded Foot Bumpers
1- Handle
1 - Handle Grip
2 - Screws, #10-16 x 1.00
Tools Required for Assembly
1 - 9/16" socket or open end wrench
1 - 3/8" socket
7-Eng D21996