Using The Work Supports - Craftsman 695.22302 Owner's Manual

USING THE WORK SUPPORTS
(Figure 42)
The two work supports are useful for:
!) Vertical support of workpieces
2) Positive stops for repetitive cuts
To use the work supports as vertical supports, loosen extension knobs and
slide extensions in toward saw. Loosen work support knobs to set top of
work supports level with table of saw. Tighten work support knobs. Position
extensions and tighten knobs. See Figure 42.
To position work support for use as positive stop, slide extension out to
desired measured distance from saw blade. Tile workpiece should rest on
the metal bracket and butt up against the plastic support pad. Tighten
extension knob.
Fig. 42
Set top of work
supports level with
table of saw.
Work support
adjustment knob
Slide extension out to
set stop dist&nce for
repetetive length cuts.
Extension knob
31