Table of Contents
Advertisement
INSTALL SUPPORTS
(Figures
15 and 16)
Fig. 15
L (two)
t
Position a support connector
(K) on end Of each extension and tighten Phillips-
head screw to secure.
Add knob (L), screw (P), and washer (Q) as shown.
For both sides, the knob should face the front of the stand.
See Figure 16.
Add work supports
(E) and (F) on each end of stand. The long side of each
support should point toward front of stand. Tighten knob (M) to secure support.
NOTE:
When inserting the work support assemblies
(E and F) into the support
connector
(K), you may encounter
a slight interference.
The interference
can be overcome by first loosening the knob (L) and pushing the work support
assembly down from the top. The second step is to push the oval support
tube up from the bottom.
Repeat these steps a few times to provide additional
clearance and allow for smooth adjustment
of the support bracket.
Fig, 16
\
Q
\
K
16
Advertisement
Table of Contents
